Page Comparison

...

• 3) On the Events page locate the textbox to the right of the “All Devices” dropdown. Type “sensors.db” in this textbox as a filter (see image below). If all went well, you should see one sensors.db event for each Reference Node you paired.

...

• Over time you’ll see two additional types of events in Notehub.

  • air.qo events report the temperature, humidity, and barometric pressure from the node's onboard BME280 environmental settingsensor. The nodes take hourly environmental readings by default.

  • motion.qo events report motion detected from the node's onboard PIR motion sensor. The node reports motion as soon as the sensor detects it, however, the node will only send one motion.qo event every 15 minutes to save on battery. The event’s count reports the number of times the sensor detected motion since the previous motion.qo, and the event's total reports the number of times the sensor .

...

• • detected motion since the device was last reset.

And with that, you have now completed the setup of your Sparrow Development Kit! For next steps we recommend that you:

...