Page Comparison

...

• 3) On the Events page locate the textbox to the right of the “All Devices” dropdown. Type “sensors.db” in this textbox as a filter (see image below). If all went well, you should see one sensors.db event for each Reference Node you paired. Over time , you’ll see two additional types of events in Notehub that .

  • air.qo events report the temperature, humidity,

  barometric pressure, and motion captured from each of your two Reference Nodes

  • and barometric pressure from the node's onboard BME280 environmental setting. The nodes take hourly environmental readings by default.

  • motion.qo events report motion detected from the node's onboard PIR motion sensor.

...

And with that, you have now completed the setup of your Sparrow Development Kit! For next steps we recommend that you:

...