Page Comparison

...

At this point you’ve now successfully updated the firmware on your Sparrow board. You can verify the installation succeeded by completing the following steps in a serial terminal application, such as CoolTerm or TerraTerm.

1. Connect to the STLINK-V3MINI serial terminal at 9600-8-N-1.

2. Press RESET button on Sparrow.

3. Verify the updated firmware by referencing the banner message (example shown below).

   Code Block
   =================== ===== SPARROW ===== =================== Feb 24 2022 15:19:28

...

You can verify the installation succeeded by completing the following steps in a serial terminal application, such as CoolTerm or TerraTerm.

1. Connect to the STLINK-V3MINI serial terminal at 9600-8-N-1.

2. Press RESET button on Sparrow.

3. Verify the updated firmware by referencing the banner message (example shown below).

   Code Block
   =================== ===== SPARROW ===== =================== Feb 24 2022 15:19:28